Fetterville Sales - About Pole Buildings

Why a Fetterville Building?
For over 25 years, Fetterville Sales has distinguished itself from its competitors by providing top notch quality and service at a fair price. We know how important the "planning stage" is to constructing these types of buildings. That's where our sales staff distance themselves from our competitors. Our sales people not only make the arrangements for you to buy a building, they assist you in the design process and see the job thorough till completion.

Each of these type of buildings take on a life of their own and no two are alike. Each one reflects your personalized touch; combining affordability with a design custom tailored to meet your needs. We're looking forward to working, and creating, with you!

Why Do Ours Look Better?
We are always asked WHY our buildings look much better than our competitors The answer is simple – we use 1 solid sheet of steel on the gable ends of our buildings. This feature, exclusive to Fetterville Sales, has been a trademark of the quality that we put into each and every building that we build. Just another fine detail that we offer on all of our buildings!

You can see the difference: Our solid sheet of material, and our competitor's Z-trim to connect the gable steel. Which look do your prefer?

Our Own Fleet of Trucks Our company owned fleet of trucks is the key to shipping the 1-piece gable steel efficiently and without damage. These tri-axles boast 26' roll off beds to insure a smooth transition every time - from the truck bed to delivery.

PROCESS - FAQs
What About Building Permits?
It is the customers responsibility to apply for the permit if it is required. You will need to check with your local government building office or homeowners association on any restrictions (size, height, materials, etc.) or required setbacks from your property lines. Fetterville Sales will provide specs and drawings For your new building; however, if engineered sealed blue prints are required, additional fees would apply.

What About Site Preparation?
You will need to provide us with a level building site approximately 3 feet large than your building on all sides. Adequate provision should be made for draining away from the site. Final leveling and grading may be needed after the completion of your building.

What Building Sizes are Available?
We can custom build practically any size. You determine the size that fits your needs. However using standard lengths and widths will be economically beneficial to you. See Standard Size Chart.

How Can I Keep My Building Cost Effective?
Some suggestions:
- By using standard lengths and widths. See Standard Size Chart.
- By using 29 gauge steel for roofing and siding.
- By staying with a standard 4/12 roof pitch.
- A sliding door is slightly less expensive than overhead garage door.

Doors and Windows?
Our sliding doors are economical and you get the benefit of a door opening to the bottom of the truss. Overhead doors require at least 1' between the top of the door to the bottom of the truss. However, they seal off better than the sliding doors. Standard residential overhead doors are 9' wide and 7' or 8' high. Our standard windows are:
- 3' wide X 2' high
- 4' wide X 3 high

How Do I Finish the Inside of My Building?
Standard building packages have an unfinished interior with your dirt or gravel as the floor. There are many different methods to insulate and finish the interior of your new building. Your may want to consider a rigid insulation board installed directly under the roof to eliminate condensation. If you intend to put your own ceiling in at a later date, make sure you add in the cost for a higher loading on the bottom chord of the roof trusses. We do not offer concrete floors.

What is the Construction Procedure?
The average lead time from signing a contract to completion of the building can vary from 4 to 8 weeks, depending on the availability of our our crews. Typically our crews start the building process within a week of delivery of materials. Construction time on a standard building is usually less than one week.

What are the Payment Terms?
Every project is done on a "pay as you go" basis. A 25% deposit is required at signing of the contract. Approximately 50% is due upon delivery of the materials. One half (1/2) of the remaining balance is paid when the roof trusses are set. Then the remaining one half (1/2) is paid upon completion.